Categories

Arduino, IR remotes and X10

Posted on Thursday, December 30th, 2010 in Arduino, infrared by the machinegeek

Here is a three-part series by basbrun progressing from analyzing IR protocol to using Arduino’s to control X10 devices via IR:

Part 1 -examining the IR protocol (the USB Infrared toy could be used in this step!)
Part 2 -controlling LEDs with IR remote.
Part 3-controlling X10 devices with IR remote.

This entry was posted on Thursday, December 30th, 2010 at 4:30 pm and is filed under Arduino, infrared. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Fung: I love this offer!!!
  • Edward Mallon: I managed to get oversampling working well on cheap Arduino promini clones. Turns out all you have to do is toggle a digital pin connected...
  • TrickyNekro: A bit late for the dance but hey! I can always try!
  • Rene Jams: the basic idea is good - a neg feedback opposed to signal ground the datasheet noise density - https://datasheets.maximintegrated.com/en/ds/MAX4238-MAX4239.pdf (fig. - DC to 10kHz NOISE...
  • Geoff: Yes pleeease