Demo: Interface an SD card with the Bus Pirate

Posted on Monday, March 15th, 2010 in BP v3, demonstrations by Ian

nada demonstrates how to initialize, read, and write an SD card with the Bus Pirate SPI library. Don’t miss the GPS logger project that the SD card went into.

Get your own assembled Bus Pirate v3 for $30, including worldwide shipping.

Via Hack a Day

This entry was posted on Monday, March 15th, 2010 at 2:00 pm and is filed under BP v3, demonstrations. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Demo: Interface an SD card with the Bus Pirate”

  1. Sjaak says:

    Another way of interfacing a SDcard is an oldskool 5″25 floppy interface (card-edge connector).

    Or am I getting old for remembering this connector? :S :P

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!