Categories

Updated Bus Pirate manual

Posted on Tuesday, November 3rd, 2009 in Bus Pirate by Ian

man2

The Bus Pirate manual has new pages for each bus mode:

1-Wire, UART, I2C, SPI, JTAG, raw 2-wire, raw 3-wire, PC keyboard, HD44780 LCDs, MIDI

It should be easier to maintain each page and add new documentation as needed. We’re also going to leave comments enabled so you can help correct errors and omissions.

We’re still looking for a volunteer to maintain the Bus Pirate manual. This could be a good opportunity to get involved in a growing open source project, even if you’re not into coding.

This entry was posted on Tuesday, November 3rd, 2009 at 8:12 am and is filed under Bus Pirate. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Updated Bus Pirate manual”

  1. Navid says:

    I’ll raise my hand for helping with the manual.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please