Categories

Posts Tagged ‘Shapeoko’

DIY pick and place machine

Friday, April 18th, 2014

Pete has written an article detailing his DIY pick and place machine build: Above is the back side of the machine.  Along the top is a piece of DIN Rail that extends from the left and right of the ShapeOko frame.  This is where the majority of parts are installed.  Below this,...

Tags: ,
Posted in DIY, hacks | 2 Comments »

Solder stencil using Shapeoko

Monday, May 6th, 2013

Peter used a Shapeoko to cut a solder stencil for a Sick of Beige Bus Pirate v4: I purchased two Sick of Beige Bus Pirate v4 from schazamp on the DangerousPrototypes forums a couple of months ago and have been dragging my feet assembling them. I used hand soldering for...

Tags: ,
Posted in DIY, Sick of Beige | 2 Comments »

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please