Rothko clock Nixie shield with 6 IN-17 tubes

Florinc writes:

This Nixie shield was designed by Tyler around 2013, as an open source project. A little after the successful kickstarter campaign, it just disappeared. I was one of the backers and I received a couple of PCBs for my contribution. I used them to built clocks and I even wrote some review blog posts. I also re-designed the PCB from a simplified schematic (so this is a little bit different than the original).
This is the smallest Arduino Nixie shield out there that has 6 Nixie tubes on the same board (together with the high voltage supply and the tube drivers).

See the full post on Wise time with Arduino blog.

Leave a comment

Your email address will not be published. Required fields are marked *

Notify me of followup comments via e-mail. You can also subscribe without commenting.