Buy stuff

Categories

A DIY SMD pick and place tool for electronics assembly

Posted on Thursday, August 1st, 2019 in DIY, tools by DP

Here’s a DIY vacuum pick-up tool for SMD components:

This video describes a DIY Vacuum Pick-up tool for picking and placing parts from an SMD component tape. The basic design for this tool involves using a vacuum pump and a solenoid to control the vacuum to a handpiece under control of a foot pedal.

Via SDG Electronics.

This entry was posted on Thursday, August 1st, 2019 at 3:25 pm and is filed under DIY, tools. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please