Categories

Simple NTP clock using USB display module

Posted on Thursday, July 11th, 2019 in ARM, clock by DP

IMG_20190707_080953-600

Dilshan Jayakody writes:

Simple NTP clock is a maintenance-free clock application developed to work on single-board computers like Raspberry Pi, Orange Pi, etc. This clock application uses the Simple Network Time Protocol (SNTP) to get the time and display it on seven segment display which I designed.  This application is designed to work on most of the Linux based systems and had minimum dependencies with system libraries and peripherals. I developed this application to work with Allwinner H2 Plus based Orange Pi Zero board, but this can compile for other platforms without doing any modifications on the source code.

See the full post on his blog.

This entry was posted on Thursday, July 11th, 2019 at 11:31 pm and is filed under ARM, clock. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...