Categories

Ham Radio HT turns CW (Morse) transceiver

Posted on Monday, May 27th, 2019 in RF by DP

BF_CW_Hookup

Ham radio HT CW transceiver project from WhiskeyTangoHotel.com:

Really not much explanation needed; just connect as shown above.  This project uses an electronic keyer, but a simple straight key/oscillator combo could also be used.  Oh… and you will also need to know Morse Code.

This entry was posted on Monday, May 27th, 2019 at 11:55 pm and is filed under RF. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please