Categories

Building the ultimate USB power distribution system

Posted on Thursday, February 21st, 2019 in DIY, USB by DP

usbpower-final-board-600

Dr. Scott M. Baker published a new build:

My goals include:
1. The ability to switch each device on/off with a rocker or toggle switch
2. Current limiting capability via a fuse or similar device
3. Overvoltage protection
4. Visual indicator (LED) of operational status
5. Multiple independent outlet

See the full post on his blog.

Check out the video after the break.

This entry was posted on Thursday, February 21st, 2019 at 11:11 am and is filed under DIY, USB. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...