Categories

An open source VOR receiver for Airspy and RTL-SDR

Posted on Tuesday, November 20th, 2018 in open source, SDR by DP

D-VOR_PEK

A simple VOR receiver for Airspy and RTL-SDR called Vortrack by Thierry Leconte, that is available on GitHub:

In the past we’ve seen several other posts about RTL-SDRs being used to decode VOR signals, but Thierry’s implementation appears to be the easiest way to get a bearing straight away. You’ll get the most use out of the software if you install it on a portable device like a Raspberry Pi and take it out for a drive as you’ll be able to see the VOR angle changing then.

Via RTL-SDR.com.

This entry was posted on Tuesday, November 20th, 2018 at 10:57 pm and is filed under open source, SDR. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please