Categories

App note: Common mode filter inductor analysis

Posted on Sunday, November 4th, 2018 in app notes by DP

an_coilcraft_DOC200

App note from Coilcraft on the design and construction of common mode filter inductor. Link here (PDF)

Noise limits set by regulatory agencies make solutions to common mode EMI a necessary consideration in the manufacture and use of electronic equipment. Common mode filters are generally relied upon to suppress line conducted common mode interference. When properly designed, these filters successfully and reliably reduce common mode noise. However, successful design of common mode filters requires foresight into the nonideal character of filter components — the inductor in particular. It is the aim of this paper to provide filter designers the knowledge required to identify those characteristics critical to desired filter performance.

This entry was posted on Sunday, November 4th, 2018 at 5:00 pm and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...