Categories

App note: Light guides

Posted on Sunday, September 30th, 2018 in app notes by DP

an_osram_AN072

Light guide basics app note from OSRAM. Link here (PDF)

Light Guides are used wherever the light of a light source should be distributed homogeneously over a particular area, when there is a spatial distance between light source and the area which is to be illuminated.

This entry was posted on Sunday, September 30th, 2018 at 5:00 pm and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “App note: Light guides”

  1. Alan says:

    Could a thin sheet of clear perspex, plus some surface mounted LEDs, act as a Light Guide – and illuminate a keyboard?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • gant: They still have a couple of the more expensive (but still considerably cheap) 5S-I-S01 in stock...
  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!