Categories

The ARM chip that wont cost an arm and a leg

Posted on Thursday, September 27th, 2018 in ARM, dev boards by DP

2018-09-18T16 25 43.036Z-board

A small ARM developmentboard from SMDprutser, that is available on GitHub:

Searching the prerequisite Chinese websites to satisfy my shopping fetish I came across a neat little ARM Cortex-M0 chip which is an extremely good bang for buck. I believe it is the smallest chip available in a reasonable hand-solderable package (TSOP8). This board gives you everything to explore this marvel of this Chinese Semiconductor.

Project info at smdprutser.nl. It’s also up on Tindie.

This entry was posted on Thursday, September 27th, 2018 at 5:40 pm and is filed under ARM, dev boards. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “The ARM chip that wont cost an arm and a leg”

  1. Alan says:

    Is the 1.6 mm PCB a “must have” or could you go to 1.2 mm, 1.0 mm, etc?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...