Categories

App note: Detecting selfie sticks using TI audio jack switches TS3A227E and TS3A225E

Posted on Sunday, June 3rd, 2018 in app notes by DP

an_ti_scda014

Old app note from Texas Instruments on smart phone selfie sticks button detection. Link here (PDF)

Selfie sticks are becoming as common of a smart phone accessory as a pair of headphones. Because of the selfie stick’s increasing popularity, smart phone manufacturers need to be able to accommodate the accessory. This report describes the procedure required for a smart phone to detect when a selfie stick accessory is inserted into a smart phone’s audio jack receptacle using TI audio jack switches TS3A227E and TS3A225E. It shows how these devices respond to common selfie-stick implementations and how to adjust the audio jack switch’s register settings to accommodate both traditional audio accessories as well as the new selfie stick accessory.

This entry was posted on Sunday, June 3rd, 2018 at 5:00 pm and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please