Categories

Taito C-Chip: data by lobotomy

Posted on Monday, April 2nd, 2018 in Chips by DP

p-IMG_20170709_133450-600

CAPS0ff writes:

In a previous post we described some early attempts to analyze the Taito C-Chip. See Haze’s forum post for some background on the C-Chip itself.
In particular we’re interested in the EPROM. Previous efforts focused on less invasive techniques with the goal of keeping the C-Chip alive after dumping. Unfortunately, we’ve been unable to successfully send an unlock command and efforts to rebond the EPROM die have been difficult with the equipment we have on hand.
With this in mind, we took a break to regroup. If we remove the ASIC we can solder to PCB traces shared with the EPROM. Traces are documented in our wiring diagram

More details on his blog here.

This entry was posted on Monday, April 2nd, 2018 at 11:58 pm and is filed under Chips. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Craig B: Shouldn't the default be 00xxx010? Note that bit 0 appears out of order in the documentation. In that case I think the initial value is...
  • JJM: From the datasheet extract you are showing, the power up status should be 00xxx010, not 000xxx01. Bit numbering is misleading since 'measurement resolution' is apparently...
  • Jan Ciger (@janoc200): Hmm, that could actually explain why the three sensor IMU breakout I have bought a few years ago had all sorts of issues - I...
  • Travis: Is it preset to the windows 3 fingered salute?
  • Glenn: What a cool idea !