Free PCB Sunday: Pick your PCB

Posted on Sunday, March 18th, 2018 in Free PCBs by DP


We go through a lot of prototype PCBs, and end up with lots of extras that we’ll never use. Every Sunday we give away a few PCBs from one of our past or future projects, or a related prototype. Our PCBs are made through Seeed Studio’s Fusion board service. This week two random commenters will get a coupon code for the free PCB drawer tomorrow morning. Pick your own PCB. You get unlimited free PCBs now – finish one and we’ll send you another! Don’t forget there’s free PCBs three times every week:

Some stuff:

  • Yes, we’ll mail it anywhere in the world!
  • Be sure to use a real e-mail in the address field so we can contact you with the coupon.
  • Limit one PCB per address per month please.
  • Like everything else on this site, PCBs are offered without warranty.
  • PCBs are scrap and have no value, due to limited supply it is not possible to replace a board lost in the post

Be the first to comment, subscribe to the RSS feed.

This entry was posted on Sunday, March 18th, 2018 at 9:51 pm and is filed under Free PCBs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

14 Responses to “Free PCB Sunday: Pick your PCB”

  1. Enrique says:

    Keep Going

  2. cham says:

    it’s sunday!

  3. Tepa says:

    Me pcb 😃

  4. Kurt says:

    Getting an inch of snow is like winning 10 cents in the lottery.

  5. Eric Duncan says:

    Watched ya’lls Flux-Off videos recently and picked up a tube of Edsyn. Dying to try it out on these boards! :)

  6. PEDRO says:

    Yeahhh where the PCBs at!!

  7. Bill F says:

    It’s my turn!!

  8. vmorgan says:

    Emma Raughton

  9. Scott Hepler says:

    OK, go!

  10. Chris Brightly says:

    Best of luck to all, including the wayward prototypers yet to post!

  11. Peter says:


Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: I've been oversampling those thermistors with the ADC and some pin-toggle noise for a while now, and that method is good. But lately I've been...
  • Marko: armature -> amateur
  • Crawford: Dibs,
  • bill: a sunny Sunday here
  • Iain NoSpam: A very random comment from a very random commenter