Categories

Easing the pain of SWD on modern DPS:es

Posted on Monday, January 8th, 2018 in DIY by DP

IMG_0501-225x300

Johan Kanflo writes:

On newer DPS:es, the SWD connector is a JST-GH (1.25mm spacing that is) which translates to “really tiny”. The annular rings where you need to apply solder and heat for adding wires are even smaller. This is why the OpenDPS SWD Bottle is handy. Add three P50-E2 pogo pins, and connect to your favourite SWD debugger.

See the full post on his blog.

This entry was posted on Monday, January 8th, 2018 at 11:38 pm and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: After reading all the comments, I have questions: Does this mean STM32 and AVR boards/parts from dodgy online sellers are suspect? What are your opinions?...
  • Sjaak: They are available with more flash then their ST counterparts which makes them more interesting. You don't have to port the code, but use another...
  • Sjaak: I dunno if you can 'license' register definitions, but I'm not a lawyer. Since the chip is available since 2015 and I haven't heard of...
  • Sjaak: They can be found on taobao or the Chinese markets in Shenzhen.
  • KH: I've been a really good boy, I only buy MCU parts from RS and Farnell. :-)