Categories

Arduino controlled Dual Mono AK4490 DAC (part 2)

Posted on Wednesday, December 27th, 2017 in Arduino by DP

STM32_MB_1-Small

An update on Arduino controlled Dual Mono AK4490 DAC project we covered previously:

After I was certain that everything related to the software was working the way it should, I designed a “motherboard” that would take care of the following:

  • Accept the STM32F106 board
  • Accept the 3.5″ TFT
  • Accommodate an 24LC256 EEPROM chip, used to store the DAC’s configurable settings
  • Accommodate two sets of I2C signal isolators and I/O expanders
  • Include headers for the encoder, IR receiver, power relay, non-isolated and isolated I2C communication, unused uC pins, etc

See the full post here, Dimdim’s blog.

This entry was posted on Wednesday, December 27th, 2017 at 11:47 pm and is filed under Arduino. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • ConnyCola: When will the page go online? I would love to see more of the new service!
  • Edward Mallon: Dr. Beddow's instrumentation class has been building the 2016 version of the Cave Pearl datalogger for more than three years, and feedback from that experience...
  • Neal: Loose no more.
  • Crawford: Must try to win...
  • readybrek: If you like a lot of chocolate on your biscuit join our club!