Categories

RX/TX sequencer

Posted on Wednesday, May 17th, 2017 in digital radio data, PIC by DP

20170507_Sequencer_001-768x512

Lukas Fässler has designed and built an RX/TX sequencer based on a PIC16F18325,  that is available on github:

Much like the beacon keyer presented here earlier, this RX/TX sequencer is a simple but useful little device. Its typical use is in ham radio applications when a separate power amplifier (PA) and/or a sensitive low-noise pre-amplifier (LNA) is used. Care has then to be take to safely transition between RX and TX states – and that’s where this sequencer comes in.

Project info at Soldernerd homepage.

Check out the video after the break.

This entry was posted on Wednesday, May 17th, 2017 at 10:08 pm and is filed under digital radio data, PIC. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?
  • KH: Agree, so okay, I guess he must have learned from somewhere. 100nF and 1000uF is so far apart, that was jarring; it's more magic incantation...
  • Max: I have a suspicion the hefty electrolytic cap might be some sort of cargo cult carry-over from other RF-based projects - for instance, I've seen...