Categories

Lift: Millimeter-level finger tracking with Arduino and light sensors

Posted on Friday, April 21st, 2017 in Arduino, sensors by DP

Millimeter-level finger tracking

Researchers at the UC Irvine and the FX Palo Alto Laboratory present Lift, a visible light-enabled finger tracking:

By projecting encoded visible patterns onto an object’s surface (e.g. paper, display, or table), and localizing the user’s fingers with light sensors, Lift offers users a richer interactive space than the device’s existing interfaces. Additionally, everyday objects can be augmented by attaching sensor units onto their surface to accept multi-touch gesture input. We also present two applications as a proof of concept. Finally, results from our experiments indicate that Lift can localize ten fingers simultaneously with accuracy of 0.9 mm and 1.8 mm on two axes respectively and an average refresh rate of 84 Hz with 16.7ms delay on WiFi and 12ms delay on serial, making gesture recognition on noninstrumented objects possible.

More details in the team’s published paper (PDF!).

This entry was posted on Friday, April 21st, 2017 at 2:20 pm and is filed under Arduino, sensors. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...