Categories

MPPT solar charger rev c

Posted on Friday, April 14th, 2017 in DIY by DP

pics-20170331_SolarCharger_008-8-600

Lukas Fässler from Soldernerd has been working on revised version of his MPPT Solar charger project:

Over the last few weeks I have been quite busy with my MPPT Solar Charger project. I’ve built up a first board and started writing firmware for it. Since the last version was not too different in terms of hardware I was able to re-use most of that code. But I hadn’t even touched on the whole USB stuff back then so there was still a lot of work to do. While the project is still far from being complete I am happy to say that I’ve made quite some progress. Most importantly, the new design seems to work well and so far I haven’t found any mistakes in the board layout. But let’s go through this step by step.

More details at Soldernerd homepage.

This entry was posted on Friday, April 14th, 2017 at 3:34 pm and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Chip Stewart: I'd love one of these!
  • zofz: you can switch off the "trimming", see http://cdn.zofzpcb.com/main/Remove.png I hope this will work for you :)
  • Steve: We're gearing up for another busy fall with the student and we love Free PCBs
  • William Worthy: Hello! Me want pcb
  • stonetronics: Yes Plesse!