Categories

Printed Circuit Board V-Groove cutting machine

Posted on Wednesday, January 11th, 2017 in PCBs by DP

This is how V-Grooves are cut into PCBs. V-Grooves are half-cuts into the PCBs that allow them to be snapped apart easily. Minimum V-Groove cut length in generally 8cm due to machine cutting length. V-Grooves must be cut across the entire PCB length, it is not possible to make short internal cuts.

This is from our PCB documentation at DirtyPCBs.com about check it out for more PCB manufacturing details.

This entry was posted on Wednesday, January 11th, 2017 at 12:23 pm and is filed under PCBs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Drone: So these go for around $330 USD and NO published calibration procedure online or otherwise? Given what's inside - I don't think I'll be considering...
  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?
  • KH: Agree, so okay, I guess he must have learned from somewhere. 100nF and 1000uF is so far apart, that was jarring; it's more magic incantation...