Categories

App note: Using the Configurable Logic Cell (CLC) to interface a PIC16F1509 and WS2811 LED driver

Posted on Saturday, December 17th, 2016 in app notes by DP

apps1

An application note (PDF!) from Microchip on how to use CLC to interface a PIC16F1509 and WS2811 LED driver:

The Configurable Logic Cell (CLC) peripheral in the PIC16F1509 device is a powerful way to create custom interfaces that would otherwise be very difficult. One example is the single-wire PWM signal, used by the WS2811 LEDs, well known in LED video display systems. This application note will provide a simple demonstration of a WS2811 LED Strip driver.

This entry was posted on Saturday, December 17th, 2016 at 4:40 pm and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Max: Hey, good job quoting as an abstract something the author writes about someone else's project... For the record, I do appreciate the proper attention to...
  • imqqmi: Also interesting to note that arduino's use the DTR signal to reset the device. I found this out because repetier was able to do this...
  • Kevin: A bit sad that you are using a knock off Saleae device unless you are not using Saleae software.
  • Max: For the Haxxor Edition he could add a Morse-to-scan-code translator to the code in the PIC (where the L337 Haxxor Special also accepts Unicode code...
  • KH: Someone with a PIC16F1459 project, well you don't see these every day. Methinks he repeats the USB 2.0 thing too much; this might mislead people...