Categories

Designing a mains frequency monitor

Posted on Monday, June 20th, 2016 in PIC by DP

mainsfreqmon_brd3-600

Dan Watson writes:

This is the second in a series of posts about designing a mains frequency monitor using the Microchip PIC 16F1619 microcontroller. In this post we will take a look at the first revision of the board that I designed for the project and some of the features that it adds.
Be sure to read Part 1 of the project write-up if you haven’t done so already.

More details at The Sync Channel blog.

Check out the video after the break.

This entry was posted on Monday, June 20th, 2016 at 1:06 pm and is filed under PIC. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please