Categories

Eagle CAD tips and tricks, part 2

Posted on Tuesday, May 17th, 2016 in tutorials by DP

cad

Here’s the part 2 of Yahya Tawil’s Eagle CAD tips and tricks¬†we covered previously:

In part 1, we talked about the importance of issuing commands with your keyboard and using your mouse effectively. In this part, we will continue talking about other useful tips and tricks for using Eagle CAD.
Read part 1’s tips and tricks here.

More details at All About Circuits homepage.

Via the contact form.

This entry was posted on Tuesday, May 17th, 2016 at 5:29 am and is filed under tutorials. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Eagle CAD tips and tricks, part 2”

  1. Sjaak says:

    Keep them coming!

  2. Simon says:

    Trick #5 will be very useful. Somewhat weird advice in part 1 though. I prefer binding the commands (move, group, route, ripup/delete) to alt+q/w/e/r with the assign tool instead of typing them.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please