Categories

INA219 current sensor DIY Breakout board

Posted on Friday, January 1st, 2016 in DIY, sensors by DP

23577455661_4c48a0beca_z

INA219 current sensor DIY Breakout board project from Juan Ignacio:

Another small board, this time for a INA219. The INA219 is a high-side current shunt and power monitor with an I2C interface.
For testing I used Rei VILO library with a MSP430G2553 and Energia, and I measured the power consumption for this simple circuit.

Project info at ssihla homepage.

This entry was posted on Friday, January 1st, 2016 at 3:27 pm and is filed under DIY, sensors. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please