Categories

CC2538 development board

Posted on Tuesday, December 22nd, 2015 in dev boards by DP

cc2538-development-board-3

Jelmer Tiete designed and built a development board for the TI CC2538, that is available at GitHub:

It’s a nice little system-on-chip with an ARM Cortex M3, 2.4 GHz 802.15.4 radio and it runs at 32 MHz. Perfect for all your favorite Internet Of Things (IOT) shenanigans. Contiki supports this chip pretty well, which means easy 6LoWPAN, RPL and CoAP support.

Project info at Jelmer’s blog.

 

This entry was posted on Tuesday, December 22nd, 2015 at 9:17 pm and is filed under dev boards. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “CC2538 development board”

  1. incar says:

    thank you

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please