Categories

FM430 – A MSP430 and TEA5767 project that lets you listen to clear digital FM

Posted on Wednesday, May 20th, 2015 in DIY, MSP430 by DP

FM430_-_A_MSP430_and_TEA5767_project

From the comments on our earlier FM radio receiver post.  Rohit Gupta shows off his digital FM Receiver on MSP430 using TEA5767:

I completed one yesterday using the MSP430 and TEA5767 Chip. Gave it a minimalist switch to toggle the channels stored in an array. Gives realtime channel strength and transmission quality values too over serial.

Code is shared on Github.
Check out the video after the break.

This entry was posted on Wednesday, May 20th, 2015 at 8:16 pm and is filed under DIY, MSP430. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “FM430 – A MSP430 and TEA5767 project that lets you listen to clear digital FM”

  1. r4k says:

    Always nice to know the DP mods are listening. ;-)

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please