How to drive a latching relay

drivingcircuit-600

Kerry Wong writes:

Latching relay (a.k.a. impulse relay) can be turned on and off by momentarily applying a voltage across the relay coil. The relay would maintain in its last switched state without the need to maintain the coil current. In this post, I will show a simple circuit which can be used to drive such relays. In the video towards the end, I also included more explanations and some demonstrations.
The relay I am using here is a latching RF relay. It is used to switch the input signal between its two outputs. For this particular relay, the input has an APC-7 connector. One side of the output has an N connector and the other side is 50 Ohm terminated. Although this relay is an RF relay, the method I described below is applicable to any latching relays.
Many dedicated ICs (such as MAX4820, MAX4821) can be used for driving such relays. Because of nature of the latching relay, no H-bridge is needed (although you can definitely use an H-bridge, but it would be wasteful).

Leave a comment

Your email address will not be published. Required fields are marked *

Notify me of followup comments via e-mail. You can also subscribe without commenting.