Categories

Bus Pirate V4 LCD adapter

Posted on Friday, November 28th, 2014 in BP v4, LCD by DP

buspiratelcd1

Dave of V-Tech Design wrote an article on how to modify a Bus Pirate LCD adapter for the Bus Pirate V4:

Why do this? At the time of this writing Dangerous Prototypes had not developed a new LCD adapter for the Bus Pirate V4 and I needed one for a project. So why not modify the existing V3 model. I unsoldered the existing header from the Bus Pirate LCD Adapter and wired a 10 pin header cable to the LCD Adapter

Get an LCD adapter for $9.

This entry was posted on Friday, November 28th, 2014 at 3:35 pm and is filed under BP v4, LCD. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • lostengineer: hahaha an entire article just saying to heat-shrink your wires or glue them if they might move around a lot. When did common sense die?
  • readybrek: They're tasty tasty very very tasty... they're very tasty.
  • hli: Sunday++
  • Chamod: Check on your buddy. Make sure they don't forget their lunchbox.
  • Kurt: But February made me shiver With every paper I'd deliver Bad news on the doorstep I couldn't take one more step