Flashing a Nixie with an Arduino

nixie

Kevin Rye writes:

I’m in the very early stages of prototyping a nixie clock. I picked up some MJE340 power transistors to switch on some IN-3s. I can then use a digital pin on my Arduino to turn on the IN-3s through the transistor. I’ll then have myself a blinking colon for my nixie tube clock.

Check out the video after the break.

Join the Conversation

1 Comment

  1. Yay cool :o)

    I built a nixie clock with a PIC a while back. I pinched the last “digit” from the BCD signal it runs on, fed the bit into a monostable to get a steady on/off cycle…

Leave a comment

Your email address will not be published. Required fields are marked *

Notify me of followup comments via e-mail. You can also subscribe without commenting.