Categories

Steam turret tank R/C controller

Posted on Monday, September 29th, 2014 in DIY, PIC by DP

rc_controller

An instructable for a PIC based R/C servo controller by Steamhobby:

The controllers capture the R/C receiver output, optionally manipulate the samples, then regenerate new servo control signals. As such, they greatly enhance what is possible with cheap servos.  They were created for my Steam Turret Tank Instructable.

Via the contact form.

Check out the video after the break.

 

This entry was posted on Monday, September 29th, 2014 at 12:00 pm and is filed under DIY, PIC. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Steam turret tank R/C controller”

  1. scanboostar says:

    What happened to the PCB Sunday?

  2. Ducky says:

    I know this post is about the servo controller, but damn, that is a sexy tank!

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please