Categories

Avalanche pulse generator- part 2

Posted on Thursday, September 11th, 2014 in DIY by DP

Avalanche pulse generator

 ssihla has been working on a pulse generator project. He writes:

I build a more permanent version of the pulse generator with some changes. The comparator wasn’t working very well with the 1V reference I was using. I made some measurements with different voltage references and got this

This entry was posted on Thursday, September 11th, 2014 at 7:00 pm and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Avalanche pulse generator- part 2”

  1. Drone says:

    OK, so where’s the link?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please