Categories

DIY binary wrist watch

Posted on Wednesday, August 13th, 2014 in DIY, PIC by DP

DSC_0035

Elia wrote an article detailing his binary wrist watch project:

I have just finished my binary wrist watch project (well, the new revision anyway). I was surprised at how small I was able to make it compared to last time.
I chose to go with the “super-yellow” color LEDs as they fit the purple OSHpark PCB very nicely. The biggest challenge was actually making a good looking wrist band for the watch. I originally intended to use a design like this but it turned out that due to lack of enough para cord I had left, I went with a simpler design that I had done once before.

This entry was posted on Wednesday, August 13th, 2014 at 5:01 pm and is filed under DIY, PIC. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...