Categories

Beach Buddy, a 3-in-1 solar phone charger, boombox, and sunburn timer calculator

Posted on Thursday, August 7th, 2014 in DIY, hacks by DP

F138XW2HYHGEPC4

An all-in-one, water and sand resistant, solar charger, audio speaker system, and sunburn timer calculator by starwisher.  Check out the project’s instructables page here:

This Instructable harnesses the power of Arduino, a UV sensor, and simple mathematics to make one nifty gadget sure to boost your outdoor summer fun – and minimize your indoor summer recovery!

This entry was posted on Thursday, August 7th, 2014 at 1:00 pm and is filed under DIY, hacks. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Daniel: Do I comment here or on FB?
  • Craig B: Shouldn't the default be 00xxx010? Note that bit 0 appears out of order in the documentation. In that case I think the initial value is...
  • JJM: From the datasheet extract you are showing, the power up status should be 00xxx010, not 000xxx01. Bit numbering is misleading since 'measurement resolution' is apparently...
  • Jan Ciger (@janoc200): Hmm, that could actually explain why the three sensor IMU breakout I have bought a few years ago had all sorts of issues - I...
  • Travis: Is it preset to the windows 3 fingered salute?