LM386 low voltage audio power amplifier

Posted on Monday, July 21st, 2014 in DIY by DP


Zx Lee published a low voltage audio amplifier build:

Today, I am going to share on how you can make a low voltage audio amplifier. For this project, I am using LM 386 Audio Amplifier, which is commonly used among electronics hobbyist. I will break the article into a few sections. First, I will explain about the LM 386 chip itself. Then move on with some explanation on the parts used in this project. And finally, the design of audio amplifier.

Check out the video after the break.

This entry was posted on Monday, July 21st, 2014 at 11:00 am and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

3 Responses to “LM386 low voltage audio power amplifier”

  1. KH says:

    A datasheet-centric article, I’ve no complaints on that bit. But it has to be said that in the year 2014, LM386 is a very old part. As a “low voltage audio amplifier” it is barely suitable if you have a portable audio project and want to use Li-po or 2xAA power efficiently. Many much better parts exist. TPA321 from TI, a modern version of MC34119, will give you 2.5-5.5V operation and shutdown capability (<1uA in shutdown versus 4mA quiescent for LM386) or one can move to a class-D amp such as PAM8403. So remember boys and girls, if you are planning a portable audio project with a LM386 that uses expensive 9V batteries, you're seriously hamstrung and limited.

  2. ee says:

    I’d *almost* agree, except that the LM386 is still not bad compared to contemporary devices if your requirements are not hi-fi. If you want basic audio out of a speaker for a project (e.g. for announcements, alarms, etc), LM386 still is usable, super-cheap, want to run from 5V supply, and comes in DIL for those who require this. It’s not as hissy as sometimes people make out (usually they have high gain set) and is reasonable quality. (But I agree this is not the device for a PP3 9V project).
    There are still people using TBA810 and that’s ridiculous :-)
    So while TBA810, LM741 etc can be just sad, I think LM386 is still just-about in the “ok” category in certain conditions :-)

  3. pravingunjal says:

    Which one is have a powerfull sound LM386 or PAM8403

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please