Categories

Laser cut Mitre joints

Posted on Tuesday, June 17th, 2014 in DIY by DP

Laser-Cut-Mitre-Joints

Martin Raynsford of Just Add Sharks writes:

Here at Just Add Sharks, we’ve been running some experiments using these cutting jigs and the results are pretty promising. The first and arguably most useful jig holds the material at 45 degrees to the laser beam. The panels that make up the box were cut to size before the machine was set up to accept the mitre jig.

Via Hacked Gadgets.

This entry was posted on Tuesday, June 17th, 2014 at 1:00 pm and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please