Digital audio amplifier with PLL synthesized FM radio

Posted on Wednesday, June 11th, 2014 in AVR, digital radio data, open source by DP


Another open source hardware project by Dilshan Jayakody the digital audio amplifier with PLL synthesized FM radio:

This is high quality stereo digital audio amplifier with PLL synthesized FM radio receiver. Some of the high level specifications of this receiver are listed in below:

  • Audio output power: 4W + 4W (with 8ohm speakers)
  • Input sources: FM and 3 external stereo line inputs
  • FM frequency range: 88.00MHz – 108.9MHz
  • Supply voltage: 12V – 15V (2A current source is recommended)
  • Tone control options: Bass, Treble and Loudness control
  • Bass / Treble boost: 14dB
  • Bass / Treble cut: 14dB
  • Station memory: Preset 10 FM radio stations
  • FM tune options: Auto and Manual with 25 kHz steps

All the source codes and design files are available here.

This entry was posted on Wednesday, June 11th, 2014 at 1:00 pm and is filed under AVR, digital radio data, open source. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Digital audio amplifier with PLL synthesized FM radio”

  1. KH says:

    I have doubts whether it should really be called a “digital audio amplifier”, would others like to weigh in? The uPC2002 seems to be an NEC work-alike of TDA2002, a bipolar tech class B linear audio amp. PT2314 seems to be from Princeton Tech (Taiwan) — this chip allows audio to be “controlled digitally”, but I’m sure there isn’t any DSP inside it. TEA5767 is a well-known FM radio chip. The audio pipeline seems to be analog from the FM output to the speakers. It is only controlled uh, “digitally”.

    So is the moniker “digital audio amplifier” accurate or inaccurate? Seems a bit of a stretch to me.

    A bit big if you ask me. I’d rather save some power with a class E audio amp.

  2. Hector says:

    Agreed, this is not a Class-D amplifier, which would be my definition of a “digital audio amplifier”.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please