Categories

DIY prototyping board with 3.3V, 5V, 12V and -12V built in power supplies

Posted on Monday, June 9th, 2014 in power supply by DP

diy-prototyping-board-header

Electro Labs’ new project the DIY prototyping board with 3.3V, 5V, 12V and -12V built in power supplies:

This DIY Prototyping Board is designed to provide all the most used supply voltages that a designer will need during prototyping a circuit. The switching power supplies on the board output 3.3V, 5V, 12V and -12V rated at 1A independently. In addition those there are two precise voltage references at 5V and 2.5V provided especially for op-amp based applications.

This entry was posted on Monday, June 9th, 2014 at 11:00 am and is filed under power supply. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please