Buy stuff

Categories

Chipstomp assembly – Analogue side

Posted on Friday, June 6th, 2014 in Arduino, DIY, PIC by DP

img_0744 (1)

We previously covered Catmacey’s Chipstomp digital side. Now he built the Chipstomp’s analogue side:

It’s done.  I’ve assembled the analogue side of the Chipstomp and finally have a fully working device.  There were no errors to fix this time which was a nice surprise.  Just lots of fiddly 0805 surface mount components to place.

Check out the video after the break.

This entry was posted on Friday, June 6th, 2014 at 2:23 pm and is filed under Arduino, DIY, PIC. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please