Creating a Spotify remote with an Arduino and LCD shield

Posted on Tuesday, April 22nd, 2014 in Arduino, code, hacks by the machinegeek

Steven from Hackshed writes about their latest project.

We have put together a Spotify remote using an Arduino and LCD Shield; it uses a .NET application as a controller and communicates with the Arduino to take input via push buttons and output to the LCD.

Project details are available from

This entry was posted on Tuesday, April 22nd, 2014 at 12:01 am and is filed under Arduino, code, hacks. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Creating a Spotify remote with an Arduino and LCD shield”

  1. Marius says:

    Very nice!

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!