Bus Pirate Demo Board 1: 1 Wire devices

2014-03-09-11.47.41

Andrew Rohne writes:

In learning how to use the Bus Pirate, I started with the one-wire area of the demo board.
First off, important notes:
-I’m using the v 3.8 Bus Pirate. The pinout is different than some of the others.
-I’m using a Sparkfun Bus Pirate cable.

The first part of this is based on using the DS2431 1,024 bit (1 kilobit?) EEPROM. The second part is using the DS1822 temperature sensor.

Leave a comment

Your email address will not be published. Required fields are marked *

Notify me of followup comments via e-mail. You can also subscribe without commenting.