Bus Pirate v3.8 free PCB build

Posted on Wednesday, March 5th, 2014 in builds by DP


Markus Gritsch posted picture of his free Bus Pirate v3.8 PCB build.

If you build a free PCB we’ll send you another one! Blog about it, post a picture on Flicker, whatever – we’ll send you a coupon code for the free PCB drawer.

This entry was posted on Wednesday, March 5th, 2014 at 1:00 pm and is filed under builds. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

7 Responses to “Bus Pirate v3.8 free PCB build”

  1. Chris McKernan says:

    Hard part is getting the initial coupon code for a free PCB to build – he did the easy part – j/k j/k – Good job soldering the surface mount components Markus!

  2. Why not make the leds and the header on the other side ?

  3. Teme says:

    Me me Pirate

  4. Markus Gritsch says:

    One question: Has anyone an idea why R5 in the corresponding schematic has a value of 2k instead of like being the same as the other 10k resistors from RN3?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!