Categories

UDP bootloader for Atmega328p + ENC28J60

Posted on Tuesday, November 26th, 2013 in dev boards by DP

UDP_bootloader_for_Atmega328p

Kehribar writes, “I’ve recently published my “UDP bootloader for Atmega328p + ENC28J60” project.  Hardware development is done on my “Embedded ethernet gateway” project.  You can find the blog post about this project from here

Via the forum.

This entry was posted on Tuesday, November 26th, 2013 at 11:06 am and is filed under dev boards. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “UDP bootloader for Atmega328p + ENC28J60”

  1. misha says:

    BOOTP and TFTP have been invented for similar purpose many years ago. I also would say that STM32F100CBT6B (or other low cost ARM uC) is more appropriate and cheaper (according to DigiKey.com) option for this project.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...