Categories

Working with the Bus Pirate Arduino Shield

Posted on Thursday, November 14th, 2013 in Bus Pirate by DP

2013-11-11-21.08.39-1

Andrew Rohne writes:

The Bus Pirate Arduino shield is a discontinued item from Dangerous Prototypes. I picked up the PCB via a free PCB coupon a while back, built it a few months later, and then finally decided to use it because I think I have something to use it with. Note the key word – think. This is what happens when a traffic engineer plays with electronics.

Get your own handy Bus Pirate for $30, including world-wide shipping. Also available from our friendly distributors.

This entry was posted on Thursday, November 14th, 2013 at 11:00 am and is filed under Bus Pirate. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

4 Responses to “Working with the Bus Pirate Arduino Shield”

  1. Andrew Rohne says:

    There WILL be more to come. I noticed a few unsoldered pads on the demo board (to go along with the missing parts that should arrive tomorrow). I hope to get some time in with this over the weekend and post more about using the demo board with the Arduino shield before I go hog-wild with it :-)

  2. Kevin says:

    Is that couch ESD safe?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Daniel: Do I comment here or on FB?
  • Craig B: Shouldn't the default be 00xxx010? Note that bit 0 appears out of order in the documentation. In that case I think the initial value is...
  • JJM: From the datasheet extract you are showing, the power up status should be 00xxx010, not 000xxx01. Bit numbering is misleading since 'measurement resolution' is apparently...
  • Jan Ciger (@janoc200): Hmm, that could actually explain why the three sensor IMU breakout I have bought a few years ago had all sorts of issues - I...
  • Travis: Is it preset to the windows 3 fingered salute?