Categories

Propeller Halloween pumpkin project

Posted on Monday, October 28th, 2013 in Holiday, LEDs, Parallax Propeller by the machinegeek


This project uses a Parallax Propeller Project board with microSD card attached, PIR sensor, LM386 Audio Amp, IRL520 FET and associated discrete components to make an animated Halloween prop. The PIR inside the pumpkin senses motion and when triggered it plays a WAV file from a microSD Card while flashing an internal light, causing an eerie glow inside.

Full build details and Propeller SPIN source code can be found at Learn.Parallax.

This entry was posted on Monday, October 28th, 2013 at 12:01 am and is filed under Holiday, LEDs, Parallax Propeller. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • gant: They still have a couple of the more expensive (but still considerably cheap) 5S-I-S01 in stock...
  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!