Categories

High-voltage seven segment LED display driver with SPI interface

Posted on Tuesday, October 15th, 2013 in Interface, LEDs by DP

HV7SEG_Arduino

Raj writes:

This is about my new project, which is a High-Voltage Seven Segment LED Driver with a serial interface. The goal is to simplify the interface of bigger seven segment display modules to 5V microcontrollers. The project provides a TTL SPI interface of MAX7219 to input display data from a 5V microcontroller and outputs functionally compatible with MAX7219 outputs but with an enhanced capability to drive high-voltage (HV) LED display modules with forward voltage up to 24V.

This entry was posted on Tuesday, October 15th, 2013 at 9:00 pm and is filed under Interface, LEDs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “High-voltage seven segment LED display driver with SPI interface”

  1. Tom says:

    The ’80s called. They want their through-hole components and 5 V DIP devices back.

  2. Sebastián says:

    Link seems broken…

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: A teacher friend asked us for faster build that was less dependent on soldering because they didn't have the budget for that kit. So we've...
  • lostengineer: hahaha an entire article just saying to heat-shrink your wires or glue them if they might move around a lot. When did common sense die?
  • readybrek: They're tasty tasty very very tasty... they're very tasty.
  • hli: Sunday++
  • Chamod: Check on your buddy. Make sure they don't forget their lunchbox.