Categories

DIY adapter for flashing ATtiny84/85 with the Bus Pirate

Posted on Thursday, August 1st, 2013 in Bus Pirate, DIY by DP

@indigoid tweeted this picture of his DIY adapter for flashing ATtiny84/85 with the Bus Pirate:

Very dodgy DIY adapter for flashing ATtiny84/85 via Bus Pirate. Shown w/ ATtiny85. No more jumpers!

Get an assembled Bus Pirate for $30, including world-wide shipping. Also available from our friendly distributors.

This entry was posted on Thursday, August 1st, 2013 at 7:00 pm and is filed under Bus Pirate, DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “DIY adapter for flashing ATtiny84/85 with the Bus Pirate”

  1. Sleepwalker3 says:

    Can the BP also program 328’s and 2560’s as well as ATtiny?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • gant: They still have a couple of the more expensive (but still considerably cheap) 5S-I-S01 in stock...
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...