Wireless power and charging test and some reverse engineering

block_charger

Dimitar Kolev writes:

I test both, just with one LED for now (like 15mA) – they was working quite OK for distances up to 1-2cm, just some paper and thin air between TX and RX coils. With appropriate ferite it seems distance and coupling can be even better.
Just to fire further my interest, chip labels on board were erased, but fortunately I found a good picture where most of the labels were visible. Unfortunately no results after some googling, but finally I think I found the manufacturer of chips and some other wireless power/charging modules – it should be Elecoteq Electronics Website is only in Chinese, so I read what I can via Google translate. I found no datasheets, but for one there was some basic description

Leave a comment

Your email address will not be published. Required fields are marked *

Notify me of followup comments via e-mail. You can also subscribe without commenting.