Categories

PCB a Week 12: BB Prince – breadboard utility PCB

Posted on Monday, July 1st, 2013 in PCBs by DP

BB-Prince Soldered1

Mats continues his challenge of designing one PCB every week.  In week 12 he came up with BB Prince, a small multi-purpose utility for your solderless breadboard:

This PAW is a small utility board for your breadboard that have some of the most common things you need when building a microcontroller-based project on the breadboard. It’s a small (2.5×1.5cm / 1×0.6”) PCB with a Power Led, a Reset button with a pullup and goes low when pressed, a Signal button with pulldown that goed high when pressed and two general Indicator Leds that are connected to ground via resistors.

BB Prince kit giveaway coming up soon! Stay tuned!!

This entry was posted on Monday, July 1st, 2013 at 1:00 pm and is filed under PCBs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “PCB a Week 12: BB Prince – breadboard utility PCB”

  1. kevin says:

    That’s a great idea.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Drone: So these go for around $330 USD and NO published calibration procedure online or otherwise? Given what's inside - I don't think I'll be considering...
  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?
  • KH: Agree, so okay, I guess he must have learned from somewhere. 100nF and 1000uF is so far apart, that was jarring; it's more magic incantation...